Common Problems Tail light bulbs are replaced with incorrect bulb causing improper operation. If tail lights stay on continuously, the headlight/tail light switch or BCM has failed. Let's Jump In! Identify the light or lights that are non operational. As far as I know there has always only been one reverse bulb on the Focus, my dads MK1 did and from what I can see on photos of other cars on Autotrader it's the same for your year of car. turn your ignition on, but don't start the car and put it in to reverse and them check the light(s). Buy Now!New Tail Light Set from 1AAuto.com http://1aau.to/ia/1ALTP00315In this video, 1A Auto shows you how to repair, install, fix, change or replace a brok Asked by Superwoman77 Dec 05, 2017 at 11:32 PM about the 2004 Ford Explorer XLT Sport V6 4WD. Question type: Maintenance & Repair. On my explorer trac, the tail lights do not wok, however, the brake lights, reverse lights and turn signals work. I've checked and replaced fuses in the. passenger compartment as well as under the hood, replaced the Hi all. My passenger side and rear lights would not work in my 2000 focus estate,checked fuse,blown. replaced and again blew. plugged out connecter in boot for lights , front lights both sides came on. next i plugged back in large brown connecter .Now both sides have stopped working and fuses have not blown and bulbs seem to be ok. removed licence plate lights and noticed they were very wet Hi everyone, thanks for the help. 1994 Ford E350 Uhaul, 7.3 IDI. The running lights, both tail and the clearance lights around the top of the uhaul box, recently stopped working. The tail running lights also serve as turn and brake signals, which still work, telling me that the ground is okay. The 30A fuse labeled "running lamps" still checking aMsZtY. Buy Now!New Tail Light Set from 1AAuto.com http://1aau.to/ia/1ALTP00315In this video, 1A Auto shows you how to repair, install, fix, change or replace a brok Symptoms Of A Bad Brake Light Switch. The most common symptoms of a bad brake light switch are trouble starting the car, malfunctions with the brake lights, issues moving the gear selector, and illuminated dashboard lights. Here is a more detailed list of the signs of a bad or failing brake light switch to look for: 1. Car Won’t Start. Car: 2001 Ford Focus SE Issue: This began when my turn signals and hazard lights would not work. The right turn signal had always worked occasionally, but a week ago the turn signals and hazard lights stopped completely. After much labor, I think the problem can be tied to a faulty turn signal assembly switch. I'm getting a new one tomorrow. The LED taillights I have are Philips Vision. The lights are pointed back, which works well with the reflectors in the Escape's taillight housing. The lights are smart enough to distinguish between tail and brake lights so I don't have a problem with them not working at night. Install was easy, literally just plugged them in and they worked fine. A simple 12V light tester and time is all you need. A green wire is for the driver side blinker and a yellow is for the passenger side. The wire for the tail lights is brown. Thats it, nothing more. The brake lights will work even if a bulb is burnt out, well except the one that is burnt out. This video shows you how to replace a burnt out rear turn signal on your 2009 Ford Focus. We recommend that you change both the driver and passenger side bulbs at the same time on your Focus as they get dimmer over time and if one is out, then the other one is likely to burn out soon. If the turn signal (also known as a blinker or flasher

ford focus tail lights not working